Simplify3D User Forum

HI,

I'm using verison 5.1.2 and have the following problem:

If I check the ironing feature then its printing the top outlines afterwards it's doing the ironing process and then the top solid is printed.
But I think it should first print the top solid and then doing the ironing.

Maybe I do something wrong, but i can't find any option to correct this issue.

regards
Roman

I ran a few tests but it always seemed to print the infill first before ironing. Can you post a factory file so we can see your exact settings?

Sure, here is the factory file.
If I play the preview line by line then I first see the the outlines, then the ironing and last solid.
It's also printing in this order.

It's really weird. I found an old profile where the problem does not exist. I changed now value by value and found something

At speed config if you set the solid infill speed to 50% then the problem is existent. If you change it to 49% or 51% the problem is gone