DLP 3D Printer support
Posted: Wed Apr 01, 2015 3:41 am
I am about to order this
http://www.gizmo3dprinters.com.au
it prints 20mm per 5 minutes,
super fast printing one layer takes around 80 milliseconds
the base is up to 405mm x 262mm
and wondering if simplify3d would dip their fingers into DLP 3d printing resin
it just needs to display a layer for x amount of time undisplay move axis redisplay new image rinse repeat
hopefully I am not posting any confidential information but I have been chatting with the creator for a while now
"what controller / stepping motor ect is being used"
Sanguinololu 1.3a with three DRV8825 steppers
Nema 23 for the 20mm Z axis ballscrew
http://www.gizmo3dprinters.com.au
it prints 20mm per 5 minutes,
super fast printing one layer takes around 80 milliseconds
the base is up to 405mm x 262mm
and wondering if simplify3d would dip their fingers into DLP 3d printing resin
it just needs to display a layer for x amount of time undisplay move axis redisplay new image rinse repeat
hopefully I am not posting any confidential information but I have been chatting with the creator for a while now
"what controller / stepping motor ect is being used"
Sanguinololu 1.3a with three DRV8825 steppers
Nema 23 for the 20mm Z axis ballscrew