Page 1 of 1
S3D 3.01 Long Pauses - Makerfarm 12"
Posted: Thu Jul 23, 2015 8:45 pm
by adamfilip
Just tried S3D 3.01 and so far im getting very long pauses (5 sec) between moves
not sure whats going on.
any advice please
Re: S3D 3.01 Long Pauses - Makerfarm 12"
Posted: Thu Jul 23, 2015 9:58 pm
by jimc
i assume this is on usb? is sd card ok? is the baud set correcty?
Re: S3D 3.01 Long Pauses - Makerfarm 12"
Posted: Thu Jul 23, 2015 11:14 pm
by adamfilip
Baud is set to 250000, same as it was with S3D 2.2
yes over USB, havent tried via SD card
Re: S3D 3.01 Long Pauses - Makerfarm 12"
Posted: Thu Jul 23, 2015 11:35 pm
by adamfilip
tired printing the same file using the same settings with S3D 2.2 and no pauses.. works normal
Re: S3D 3.01 Long Pauses - Makerfarm 12"
Posted: Fri Jul 24, 2015 8:25 am
by jimc
Check with an sd card. This will atleast tell you if its in the gcode or a com issue