S3D 3.01 Long Pauses - Makerfarm 12"

[adamfilip]

Just tried S3D 3.01 and so far im getting very long pauses (5 sec) between moves
not sure whats going on.

any advice please

[jimc]

i assume this is on usb? is sd card ok? is the baud set correcty?

[adamfilip]

Baud is set to 250000, same as it was with S3D 2.2
yes over USB, havent tried via SD card

[adamfilip]

tired printing the same file using the same settings with S3D 2.2 and no pauses.. works normal

[jimc]

Check with an sd card. This will atleast tell you if its in the gcode or a com issue