Simplify3D User Forum • Full honeycomb alignment off at first

Page 1 of 1

Full honeycomb alignment off at first

Posted: Sun Nov 01, 2015 8:24 pm

by tonyno

Thought this was an interesting find...

: Initial

It's misaligned until you change the infill type to something else, then back to full honeycomb.

: After Change

Re: Full honeycomb alignment off at first

Posted: Mon Nov 02, 2015 5:39 pm

by jimc

check to make sure you only have one infill angle entered. it should be zero and nothing else.

Re: Full honeycomb alignment off at first

Posted: Mon Nov 09, 2015 7:50 am

by tonyno

Interesting! Good call.