Page 1 of 1
How to setting software for Flashforge Finder?
Posted: Wed Nov 25, 2015 7:17 am
by 9beer
i buy Flashforge Finder and i want to use Simplify3d, anyone know how to setting this program?
thank you
Re: How to setting software for Flashforge Finder?
Posted: Thu Nov 26, 2015 6:57 am
by JoeJ
I attached a profile I have been using. It's really similar to the FlashForge Dreamer. Just export the gcode and then copy to the USB drive for printing on the machine.
PS - I'm not 100% sure about the M132 command in the starting script just yet. Some of the Finder commands seem to have changed. Can you post a gcode file that you've already printed (perhaps from FlashPrint)?? It would be good to compare against what I've been using since I've made a lot of changes to the stock flashprint settings.
Re: How to setting software for Flashforge Finder?
Posted: Wed Apr 06, 2016 5:51 pm
by el_norman
JoeJ wrote:I attached a profile I have been using. It's really similar to the FlashForge Dreamer. Just export the gcode and then copy to the USB drive for printing on the machine.
PS - I'm not 100% sure about the M132 command in the starting script just yet. Some of the Finder commands seem to have changed. Can you post a gcode file that you've already printed (perhaps from FlashPrint)?? It would be good to compare against what I've been using since I've made a lot of changes to the stock flashprint settings.
The attachment Finder.fff is no longer available
I don't know if anyone is following this thread anymore, but here is the gcode for a 10x10x10 cube that was sliced with Flashprint that was asked for. I had to change the extension because I got a message saying "The extension g is not allowed".
Re: How to setting software for Flashforge Finder?
Posted: Thu Dec 22, 2016 5:01 am
by perohlsson
The Finder.fff profile above works great for my Finder with Flashforge PLA
Thanks for uploading!
Very soon I will try PETG from 3D-Prima.
/Per