Simplify3D User Forum

When I print in ABS with my printer completely wrapped in a plastic bag, my solid print doesn't warp very much but the support loves to lift off the bed. Is there anything I can do? I have a tight first layer with a nice layer of hairspray and I even apply superglue to the edges but for larger support pieces, it will almost always lift.

Heated bed 92C, this is as high as it can really go
Extruder 230C

Slow down the first layer printing speed. Or you could also add a brim with lots of outlines to create a nice flat plastic surface (for example using 20 brim outlines)