Simplify3D User Forum

Posted: **Wed Apr 20, 2016 6:08 am**

Hi guys,

Wondering if someone can chime in on what this artefact at the front of the pointy cake-shape really is.

Layer height is 0.3, get the same with 0.2.

Thanks

Posted: **Wed Apr 20, 2016 8:22 am**

That part looks really thin. If it gets smaller than your extrusion width, you will start to see issues like this.

Posted: **Wed Apr 20, 2016 8:52 am**

CompoundCarl wrote:That part looks really thin. If it gets smaller than your extrusion width, you will start to see issues like this.

Thanks ComoundCarl.

Just for the record the nozzle width is 0.4 and the shell is 1mm with extrusion width set to 0.5 in S3D.

Simplify3D User Forum

Is this over-extrusion OR retract issue

Is this over-extrusion OR retract issue

Re: Is this over-extrusion OR retract issue

Re: Is this over-extrusion OR retract issue