Simplify3D User Forum

Posted: **Fri Jun 17, 2016 1:09 pm**

Hi, i'm from chile and i need help.

when i print with support, the part of the piece that's in contact with the support, has a very low resolution, instead the rest of the piece has a very high resolution.
i dont know wich part of the configuration i do wrong to obtain the same quality in all the piece.

I have a leapfrog creatr.

salutes!

Posted: **Tue Jun 21, 2016 8:30 am**

There's lots of similar threads on here already
viewtopic.php?f=9&t=5029
viewtopic.php?f=9&t=5275
viewtopic.php?f=8&t=4453

Posted: **Wed Jun 22, 2016 8:41 pm**

and my thread.

It's terrible now, It was great before these 'updates'.

viewtopic.php?f=9&t=5516

Posted: **Wed Jun 22, 2016 10:50 pm**

if you add dense support layers then open the gcode file in notepad.

"ctrl F" search for dense and change the speed to 1000 or so.

i get pretty good bottom layers as the dense support layer acts like a good base

Posted: **Thu Jun 23, 2016 7:40 am**

I use 3GX not sure I can alter that. I'll go back to using V2 I think. It was great with that version.

Posted: **Fri Jun 24, 2016 10:42 am**

Back to V 2 for me. This came out perfect compaird to V3

Exactly the same settings

Simplify3D User Forum

problem with bottom layer quality on support

problem with bottom layer quality on support

Re: problem with bottom layer quality on support

Re: problem with bottom layer quality on support

Re: problem with bottom layer quality on support

Re: problem with bottom layer quality on support

Re: problem with bottom layer quality on support