Simplify3D User Forum

Hi ,
After installing the new ver. of software the preview of the bed disappears right after it starts up. I can still load a model but I can not see it. If I go to prep for print the slice window opens and I can see the model them in it's sliced form.
Thanks for any help.

Well did you enable the "build table" checkbox on the left side of the preview window?

Sorry, I am talking about the start up window not the slicer preview window. But yes that is checked in the slicer window. When I first installed it, it was all working fine. It is there when I am not connected to the printer. I am printing on a Leapfrog Creatr dual.

Thanks.