Simplify3D User Forum

Hello guys!
I'm struggling on the support wall thickness generated by S3D.
The wall thickness is almost ranging from 0.6 - 0.8mm, removing it is a suicide. Got myself cut very badly from it.
Not even single one of them came out easily, both material use here is PLA (on printer: Felix Pro)

I tried tweak the support settings, it doesn't seems to help on the removal
Appreciate some help over on it, been trying for 2 days yet no good results

Your pictures aren't showing up for me, but there's lots of support separation settings that you can adjust if you need the support to break away easier. I would probably start with those.