Solid Layers between extrusions in dual extrusion.
Posted: Wed Mar 22, 2017 7:12 am
I am printing a piece with three tool changes to change color.
After I run the wizard I see that every tool change involves a solid layer as the process has the setting in it. My question is if doing this solid layer is necessary, recommended or it's just something that is not needed on middle of the object that is not exposed to the outside. Will this layer help or be a problem of adhesion when the print finishes?
After I run the wizard I see that every tool change involves a solid layer as the process has the setting in it. My question is if doing this solid layer is necessary, recommended or it's just something that is not needed on middle of the object that is not exposed to the outside. Will this layer help or be a problem of adhesion when the print finishes?