print quality advice
Posted: Fri Apr 14, 2017 7:39 am
- bad side
- bad side
- good side
Simplify3D User Forum
Simplifying the 3D Experience!
https://forum.simplify3d.com/
print quality advice
Page 1 of 1
Hi, can somebody help me please, I have a K8200 with lots of upgrades, a twin K8204 trapzoid, a K8203 1.75mm hot end as well as other things to help improve print quality, I just printed off a new fan nozzle and mostly I am happy with the print, except for one part at the rear of the print is very very poor
Re: print quality advice
Posted: Fri Apr 14, 2017 11:52 am
You might want to try adding support for those steep overhangs. Or lower the layer height in that area.
Re: print quality advice
Posted: Fri Apr 14, 2017 7:27 pm
You need a better cooling fan/ system, but I bet you are printing this because of that 