Hole or Boolean difference option/setting?
Posted: Fri Jun 30, 2017 11:12 am
Is it possible to cut off the object from the object? In Meshmixer it is called the Boolean difference in Tinkercad just a Hole.
Simplify3D User Forum
Simplifying the 3D Experience!
https://forum.simplify3d.com/
Hole or Boolean difference option/setting?
Page 1 of 1
Re: Hole or Boolean difference option/setting?
Posted: Fri Jun 30, 2017 11:29 am
As S3D is a 3D printer slicer package, and not a CAD package, then its safe to say that S3D cannot do CAD software functions.
Re: Hole or Boolean difference option/setting?
Posted: Fri Jun 30, 2017 12:38 pm
Ok, thanks. Then it is our "New Feature" request.dkightley wrote:As S3D is a 3D printer slicer package, and not a CAD package, then its safe to say that S3D cannot do CAD software functions.
I know we may asking too much, but we are too lazy to open CAD for the silly holes like that
.