Page 1 of 1
MKS SBASE 1.3 trouble connectiong
Posted: Tue Oct 24, 2017 3:35 am
by Espaider
Hi, I can not connect my printer using USB to S3D.
I select the right baud rate (115200) and have tried with both USB ports that show up when I plug the printer but I get:
Attempting connection at \\.\COM11...
Permissions error connecting to port
Is there another application already connected to this port?
Error opening selected port.
Any ideas, solutions?
Re: MKS SBASE 1.3 trouble connectiong
Posted: Tue Oct 24, 2017 6:14 am
by brian442
They have an FAQ section about this, so you might want to start by reading that:
https://www.simplify3d.com/support/faq/#faq-4630
Re: MKS SBASE 1.3 trouble connectiong
Posted: Fri Nov 10, 2017 9:15 am
by deafoldgit
I am also having this problem, I did read the above and did as it said, but I still get the same problems, machine is Vertex K8400 twin extruders
Re: MKS SBASE 1.3 trouble connectiong
Posted: Wed May 09, 2018 7:48 pm
by pnelson29
I am also having this issue, after updating my firmware.. The Baud is set for 115200 on my COM 3 in devise manager, in S3D and in my Marlin sw..
I haven't been able to connect since..
Re: MKS SBASE 1.3 trouble connectiong
Posted: Wed May 09, 2018 7:59 pm
by pnelson29
And YES I read this... I can connect that way.. But i can't do anything with it.. So it is useless
Might want to read this:
https://www.simplify3d.com/support/faq/#faq-4630
Re: MKS SBASE 1.3 trouble connectiong
Posted: Thu May 10, 2018 3:31 pm
by DarthRevan
This error typically means another software is open and already connected to the port you attempted to open a connection with.
Permissions error connecting to port
Is there another application already connected to this port?
Error opening selected port.
Do you still have the Arduino IDE open or another 3D printer controller software open? If so, try closing them and then clicking connect in S3D.