Page 1 of 1
Angled supports
Posted: Tue Mar 27, 2018 1:33 pm
by jjudge8U
Need ability to have custom angle supports. Waste of print time and speed when you are printing 500 mm tall and you have to build a support all the way from the bed for something that could start 20 mm down at a 45 degree angle off the build.
Re: Angled supports
Posted: Wed Mar 28, 2018 4:57 am
by rrdavis
Can you post a photo of the print you are referring to showing the desired supports vs the ones that got added by default?
Re: Angled supports
Posted: Wed Mar 28, 2018 10:30 am
by jab136
I don't know if this exactly what the OP was talking about but here is an stl for a part that I tried to print a while back, the cone angles are 75 degrees so they need support, but that support doesn't need to come all the way from the previous cone.
Re: Angled supports
Posted: Tue May 01, 2018 10:32 am
by jwilbourne
Please add Angled Supports