Search found 3 matches
- Mon May 05, 2014 6:33 am
- Forum: Troubleshooting and Bug Reports
- Topic: Disconnecting during printing
- Replies: 1
- Views: 2224
- Jump to post
Disconnecting during printing
Simplify3D 2.1.0 Mac OSX Leapfrog Creatr Dual Multiple objects. My Problem: After a print job of 12 hours the printer is disconnected during a print job. With the next print job with multiple objects the printer disconnects after a few minutes. I have restarted the printer, same problem. I just rest...
- Sat Apr 05, 2014 6:42 am
- Forum: Troubleshooting and Bug Reports
- Topic: GCODE not exporting
- Replies: 1
- Views: 2414
- Jump to post
Re: GCODE not exporting
Hello, I had the same problem. It has to do with rights. I installed in on Mac OS and when I installed the software I was Admin with admin rights. But later I was a normal user with no rights to write in the dir were I first saved my g-code. Check your permissions of the dir where you want to save y...
- Mon Mar 24, 2014 2:27 pm
- Forum: Feature Requests
- Topic: [DONE] Save FFF config files
- Replies: 1
- Views: 3956
- Jump to post
[DONE] Save FFF config files
What I would like to see is:
The possibility to save several FFF config files like so:
LeftExtPLA
RightExtPLA
LeftExtABS
RightExtABS
LeftExtPVA
RightExtPVA
In this way I only have to configure this files and reuse them over and over.
Kind regards,
Joost
The possibility to save several FFF config files like so:
LeftExtPLA
RightExtPLA
LeftExtABS
RightExtABS
LeftExtPVA
RightExtPVA
In this way I only have to configure this files and reuse them over and over.
Kind regards,
Joost
