Search found 3 matches
- Wed Dec 31, 2014 10:23 am
- Forum: General Discussion and Tips
- Topic: S3D and laser etching
- Replies: 2
- Views: 2373
- Jump to post
Re: S3D and laser etching
DiscoJon, Are you having any luck. I am planning on do roughly the same type project on my printer. I am using a FlashForge Creator Pro Dual. I have traded some emails back an forth with the guys at JTechPhotonics, they are very responsive and helpful. It would be very cool if there was a selector i...
- Wed Dec 31, 2014 9:50 am
- Forum: General Discussion and Tips
- Topic: Nylon Bridge print settings
- Replies: 10
- Views: 12030
- Jump to post
Re: Nylon Bridge print settings
I was going to try to put a board of MDF on my heated bed, i read some where that the Nylon618 stuck to it very well, What setting to I need to change so that the printer knows that the bed is .445 higher than it was, I tried using the start printing height under the advanced tab but the extruder cr...
- Wed Oct 22, 2014 4:44 pm
- Forum: General Discussion and Tips
- Topic: Small Parts without rafts, clicking
- Replies: 1
- Views: 1334
- Jump to post
Small Parts without rafts, clicking
Printer: Flashforge Creator Pro Dual Material: PLA I had a part from thingiverse that is a 1.75mm filament holders, built 10 at one time. Use the settings I had on another print, which included the raft. I reloaded the part and muliplied it and selected no raft or support. when the print starts the ...
