Simplify3D User Forum

Stefan_Koch

Yes, indeed !

+1

Stefan_Koch

+1 from me. More control over infill / internal support would be great. Especially, a feature like "Infill only where needed" would be a killer. Slic3r has such a feature, and I used that very often. If you activate it, Slic3r just puts infill in areas that have overhang angles above the t...

Stefan_Koch

Indeed, a feature that allows raft just under supports would be great. I very rarely use raft, as I print on BuildTak, but if I have support starting from the bed, even with BuildTak, it very often gets loose over time, which usually means the end of the print. As an interim solution, I switch on ra...

Stefan_Koch

Well, when I "hollowed out" the originally massive part (with Netfabb), I used the automatic repair funcion there, as hollowing always creates small errors. But I can check the part again in Netfabb. I suspect indeed that the artifacts have something to do with the "hollowed out"...

Stefan_Koch

Hi everybody, I´m printing a rather large hollow part (39 cm high). As the part is hollow, and the geometry allows it, I´m printing without infill or support. I´m not using the "spiral vase" function, however, as the .stl came already hollow, and the wall thickness is more than just one pe...

Search found 5 matches

Re: Supports brim

Re: Feature Request: Internal Supports

Re: Variable raft features

Re: S3D creating unwanted solid layers in a hollow part

S3D creating unwanted solid layers in a hollow part