Simplify3D User Forum

andrewpeters

I would really like this back too

andrewpeters

Could we get flow and speed multipliers back on the machine control panel?
I would really also like to movement controls on the left tab again so I can view my accessory controls side by side with movement controls.

andrewpeters

I would like it if settings like retraction, coasting and extra restart distance would save with the material

andrewpeters

I just noticed speed and flow control are also gone from machine control panel.
I'm also not a fan of the temperature readout and control being in a separate tab from the movement control but that's not really a bug or feature request

andrewpeters

I just upgraded to V5 and I noticed any time I re connect to my machine the extruder and bed temp in machine control panel default back to 200 and 60. I don't use these temps and it's getting annoying changing it back. Is there any resolution? I also noticed that live preview is gone and the estimat...

andrewpeters

thanks for the response I did get it to slice correctly rotating the part, I also noticed that if I moved the model too close to the edge it would cut the corner off which I assume is a printer issue since it looks to have sliced correctly. the filament randomly backing out I have recreated after go...

andrewpeters

here is a quick video of my slicing issue

https://youtu.be/7Fy_lKD_vXw

andrewpeters

Since updating my printer will randomly print at very low speeds around 1mm/sec for a few min then resume regular speed. It will also randomly retract at full speed for about 30 sec. I have also seen strange slicing issues that I have gotten video of which was only if I positioned my part certain ways

andrewpeters

it's called polishing or finishing
you can use a vapor chamber with alcohol for abs or chloroform for pla out of a mason jar with a small fan inside
the end result will be a perfectly smooth print

andrewpeters

So it looks like the printer is retracting between every move whether it is a print or non print move. is there a way to change this? I would like to be able to have it retract when moving farther distances and have it not retract when printing perimeter shell layers If I print a cube each time it c...

Search found 12 matches

Re: Bring back the "Infill slider" in expert mode

Machine control panel fixes

Re: Proper Material Manager

Re: V5 temps on machine control panel reset to default when reconnecting machine

V5 temps on machine control panel reset to default when reconnecting machine

Re: Issue with 3.11 with 3dp1000

Re: Issue with 3.11 with 3dp1000

Issue with 3.11 with 3dp1000

Re: Diagonal lines on finish surface

Re: lag between moves