Simplify3D User Forum

Q*bert

Please add support for these new printers. They are selling many, many printers and should be a focus for you.

Q*bert

I also have a CNC router, so the Creator interface made sense to me. It's Pronterface that's unusual when compared to many similar technologies. The good thing about the Pronterface control layout is that it takes very little thought to make things move. The bad thing about the Pronterface control l...

Q*bert

I've been playing around with the support material generation and I have a few comments/suggestions: 1) The effect of the "Horizontal Grid Spacing" is far less than intuitive. It changes both the spacing and the width/thickness of the supports in a way that I can't understand. It would mak...

Q*bert

When temperatures go above 200 degrees, the temperature graph stops tracking the actual temperature. It seems to just keep going up at the same slope it was at before it passed 200. Scared the heck out of me until I turned on "Verbose" and could see that the actual temperature was OK. On a...

Q*bert

Found it! We were messing with a lot of settings so some of them don't look so great. But check out the pyramid on the far right. That was literally one of the best calibration pyramids I have ever seen. Could you post your settings for the pyramid on the right? I'd like to replicate (no pun intend...

Q*bert

Sparky wrote:Running g-code from the M2 SD with monitor ON works for me. Running g-code via USB with monitor ON appears to choke the serial pipe.

Wow. I know this is brand new software, but this made it through beta?

Q*bert

I can generate a g-code file that previews properly, but when run using the Machine Control Panel my M2 doesn't interpret the g-code properly. The M2 seems to follow some of the g-code but then runs off in strange patterns. I can load the same Creater produced g-code file into pronterface and it run...

Q*bert

Looks like a nice implementation. Thanks!

Q*bert

I'm really excited to see another solution come to the marketplace - so much so that I ordered it for my Makergear M2 as soon as it was made available (still waiting for the download link.)

One thing I haven't seen mention of is the firmware that Creator works with. Any details?

Search found 9 matches

[ADDED] Bambu Lab X1 and P1P

Re: Feature Request - Jogging X, Y, Z and E

Support material

Temperature graph has problems above 200

Re: Feedback and Requests

Re: Machine control of M2 is goofy

Machine control of M2 is goofy

Re: Firmware?

Firmware?