Simplify3D User Forum

Mitchell_VonB

Could you post the same section from a sliced file?

Mitchell_VonB

I replied to this a couple of days ago. What happened to my post?

Mitchell_VonB

There is not a way to do this in simplify. The process system is not set up to handle the merging of multiple models in the way you need. I would recommend you use a slicer with volumetric modifiers such as Cura or Orca.

Mitchell_VonB

The most likely culprit for this is the tension on the Y axis belt. Check that and see if it is loose.

Mitchell_VonB

Is there any devblog or any sort of status update on this program anywhere that isn't just what I can maybe gleam from these forums?

Mitchell_VonB

Mitchell_VonB

This is not just a vase mode issue, it commonly happens on parts with holes near walls as well.

Mitchell_VonB

Finally had this bug happen again and grabbed the corrupted save state file. How do I get a file over 3mb uploaded properly on this forum?

Mitchell_VonB

I've encountered this many times. Simplify isn't the brightest bulb so it can only start a line on an edge of a model. I'd suggest you import a cylinder, change the scale until it looks like a single tall thin line, align that to where you want the seam to sit, then copy that cylinder's coordinates ...

Mitchell_VonB

My best guess on how add/remove multiple supports currently works is simplify clicks every time a frame is rendered while the mouse is held down. This is fine for small parts or when using large support pillars, but when slicing models for a printer with a bed area of 762x762mm fine control of suppo...

Search found 33 matches

Re: Qidi X-Plus 3

Re: How to create supports?

Re: Different parameter on different region (not on layers range)

Re: Y-axis layer shift

Devblog updates?

Re: Crash on open due to corrupted saved state

Re: Vase mode scar

Re: Crash on open due to corrupted saved state

Re: Starting point is not constant

Decouple add/remove multiple support tool from frame rate