Tip of the Day 22 - BFB 3D Touch, CubeX, RapMan & CubePro

[Yodajammies]

Has this been confirmed to work with the 1.10 firmware update? Thanks!

[logic1208]

Hi

Yes, i work with Firmware V1.10 / V2

Andy

[logic1208]

Hi

Does anyone have a working PLA Profile?

Andy

[tom]

Hi,

use Profil CubePro_Ex2.fff from -Michaelherron- and Change Extruder Temp. to 195C and the 2. Temp to 60C.
It works on our Cubepro duo

[logic1208]

hi tom

i have modified the profile with changed the extruder to ex1, and change the filament in extruder 1 to pla ).
but now the printer heats up the chamber like with abs. but with pla thats not so good

do you know where i can disable the heater for the chamber?

thx,

andy

[tom]

Hi Andi,

I don´t know how we stop the chamber, I take the top cover away and open the frontdoor

Tom

[tom]

Hi Andy,

delete in Cubepro_Ex2.fff in Scripts M404 and the Chamber is off

Tom

[logic1208]

hi tom

thank you, that was it

the heater is now off!
but i have two more problems which i have to solv.
the pla does not stick ( even with glue ) good on the bad and peal off at bigger prints.
the extruder "clacks" during prints with PLA (not with ABS, ABS works fine ), i think they extrude a bit to much fillament.
so i do some more test....

andy

[ChoreBoy]

Hello all...

I tried a print on our CubePro Trio but the printer just seem to hang at the "heating up the chamber" step and never starts printing. The little bar graph never seems to get all the way to right side.

This does not happen when sending a .cubepro file that was created by the CubePro software.

Any thoughts?

Thanks
CB

[logic1208]

now my printjob ( 12hr ) is finally done

i covered the cubepro printbed with blue paintertape and level the paltecarefully.
now the pla sticks very well to the printbed.
with the profile the first layer i think it a bit too much extrusion, because the pully snaps over.
but after thirt layer its seems ok...

andy