Can anyone give me some pointers on how to setup my SeeMeCNC Rostock Max printer with the Creator software.
I am getting crazy axis movements when running. I am sure it something basic.
Thanks
David
Re: Rostock printer setup
I am sorta waiting for more rostock support myself, along with repetier firmware support also. Since it is the firmware of choice for the deltas currently.
Or perhaps some type of instruction on setting up the Rostock or deltas in general. I have had limited success getting acceptable results so far.
Admittedly this is partially due to my lack of time in this program but also due to my firmware not showing temps etc.
Or perhaps some type of instruction on setting up the Rostock or deltas in general. I have had limited success getting acceptable results so far.
Admittedly this is partially due to my lack of time in this program but also due to my firmware not showing temps etc.
