Wrong G-Code

[barsam]

First of all I want to say that I was very happy to find out about all these new features that came along with version 3. And I am really glad that I see a lot of good effort from the Simplify3D team. Keep the good work.

Now to the bug. I created a G-code (attached here) and I edited to check about this new feature (extract while wipe). While I was looking through the code, I came across a section that is definitely a bug. It is everywhere through all the code and it starts at line 26976.
I don't think that it affects the actual code, but it is creating a lot of more kb I suppose.

[dsegel]

Weird. I see that in mine too.

[JoeJ]

It could also easily just be that those sections became too small to actually print. So it's telling you that the model has a perimeter there, but it's too small to print with your nozzle.

Do you have a factory file?

[barsam]

Actually I do not have the factory file, but you can open the Gcode in preview mode and check it out.
While I was previewing the code in line mode I noticed another bug, but that's something I will report in a different post.