Re: Printer Preview
I did pick my printer in the original configuration assistant but it didn't show the platform. I went back and did the config assistant again and it showed up. Not sure why but it is working now.
Re: Printer Preview
I'm not sure.....but I think the printer stl only views if you set a colour for it. Like Dsoguys, I had to go through printer configuration twice to get it to display.
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: Printer Preview
Must be a glitch in the software. Hope this will be fixed and more printer STLs added soon. If I get to it, I'll make one for my Rostock. It would be nice to have reference point for how they are going to print on the bed. I like to make sure the more interesting side or side I need to watch is facing out to make sure everything is going well during the print.Dssguy1 wrote:I did pick my printer in the original configuration assistant but it didn't show the platform. I went back and did the config assistant again and it showed up. Not sure why but it is working now.
