Problem with dual extruders

[Rebekah_harper]

from one of my own prints, on a single extruder you can see this between features

G1 X-80.743 Y7.212 E0.0110
G1 E-10.0000 F1200 (retraction)
; outer perimeter
G1 X-80.754 Y-7.228 F4200
G1 E9.0000 F1200 (purge)

but you don't see it on the dual. ???? why is this? surely there should be something

[Rebekah_harper]

have you tried it without grouping the process' ?

[Trax]

Without grouping it does not work at all it does not even show the pilar in the preview.

[Rebekah_harper]

I'll have another look but I am sure that everything was there when I did it.

[Trax]

Could someone who has a makerbot 1 or clone (ctc/flashforge/wanhao) please post a factory file of a 1 extruders part that he actually successfully printed with such a printer?

[JoeJ]

Their stock profile is working fine for me. Just select "right extruder only" or "left extruder only" from the extruder auto-configure drop down

[Trax]

The problem is with the "booth extruders" profile, only left and only right work great.

[JoeJ]

Just tried a print with the stock "both extruders" profile and it also worked okay. Did you make modifications to the stock settings?

[Trax]

I started changing things after it failed. Could you post your factory file so I can try something that supposedly worked ok?

[JoeJ]

I'm literally just using their stock settings. Maybe you should go to help --> configuration assistant again to reload the profiles. I haven't changed anything else.