Losing Communication to Davinci 1.0 with Repetier

[duoteknia]

Hello...

I recently flashed my DaVinci with Repetier .92 and absolutely love it, but have a couple of questions:

- How can I make S3D to connect automatically to the printer?? Every time I open S3D I have to manually connect the software to the printer, even the baud reates are the same on the printer and the software 115200 (On stock firmware, it just connected automatically)

- Is there any way in S3D to just "send" the file to the printer, so I can disconnect the USB or just shut down the computer? On Repetier, now S3D has to be connected all the time during printing (on stock firmware, it just sent the file and the printer did the rest)

Don't get me wrong , I LOVE Repetier on my DaVinci...it's just those two things that I would like to have on my printer...

Thanks in advance for all your help...

[CompoundCarl]

This should really be a new topic since it isn't really related to this thread... but anyways, I don't think Repetier supports those options, so I don't think there's any way to do those things without using the stock firmware.

[allcovered]

My Da Vinci 1.0 flashed with Repetier .92 also now connects (thanks to this thread), but it in the communcation tab of the Machine Control Panel it says:

Attempting connection at \\.\COM18...
Connected to machine!
SENT: T0
SENT: M105
SENT: M105
SENT: M105
SENT: M105
SENT: M105

and when I click on something like Home all or try to pre-heat the bed, it freezes and I need to Disconnect and then Reconnect.

Here are my settings from Repetier 1.6.0:



Here are my settings in S3D:



Any thoughts?