Da Vinci 1.0 Pro wi-Fi printing

[s73mose]

The release notes for S3D version 3.1 says there is now support for Wi-Fi printing with the Da Vinci 1.0 Pro printer.

Has anyone had any luck with getting it set up?

I updated from v3.0 to v3.1 last night and did a test print for functionality and get my printer setup.

I did not notice that Wi-Fi printing support was added for my printer till this morning.

I have been waiting since December for this release to support my printer and very excited ti is finally here!

Just the fact alone that I do not have run XYZware anymore is of great enjoyment!

If I can get my Wi-Fi print capabilities back that will be a bonus!

My printer and computer are not co-located.

I filed a support ticket this morning to see if they can point me in the right direction. Hoping I just over looked a setting or something.

Thanks!

[CompoundCarl]

There's some info about it in this thread: viewtopic.php?f=8&t=5399#p23381

[razster]

You just have to enable it on the network tab of the options window

[sfraden]

I used the Wi-Fi once. Then I shut it off and never used it again. Seems the Wi-Fi built into the machine is like the slowest of the slow, The difference between uploading a file between WiFi and USB is measured in tens of minutes. Same file took a Minute to send USB literally took 22 minutes Wifi.

Might be worth your time to run a really long USB cord