GIant Marvin Lamp

[movingimage]

I printed this with Simplify3D (by far my fav. slicer). It is a giant Marvin Lamp. It produces an awesome soft light, uses low voltage LEDs, and it fully dimmable from lamp to nite-light. It took 40 hours to print, and man was the support hard to remove from the Inside!

I've had some people ask me if I would make more, so If I get enough takers I am going to slip-cast a limited run out of white porcelain with a sintered-matte surface. They will glow just like this ABS version but be way more elegant and suitable for high-end decor. I am shooting for $100 if I can get to a reasonable quantity. You don't have to promise to get one now but if you might be interested, just give me your email address by message or on the form on my blog:

http://www.marvination.com/more-marvin/ ... arvin-lamp

[brian442]

That's an awesome idea! Looks like a really nice print too!

[movingimage]

That's an awesome idea! Looks like a really nice print too!

Let me know if you might want one so I can get some rough numbers. No obligation.

http://www.marvination.com/more-marvin/ ... arvin-lamp