[ALREADY ADDED] Smooth Z Ramping

[Fallen Munk]

Is there any way to implement smooth Z ramping instead of just a vertical jump that leaves a seam? With a ramp speed and distance option that can be set in the software? I'd find that very useful.

[brian442]

Check out the corkscrew printing mode (vase mode) on the Layer tab.

[Fallen Munk]

Check out the corkscrew printing mode (vase mode) on the Layer tab.

Thanks, I'll give that a shot on this model. I tried it once with a different model and the infill was all messed up.

[arhi]

I tried it once with a different model and the infill was all messed up.

that mode will not use infill at all, it only prints solid layers and walls, infill is zero