Brim on inner race of bearing
I've been printing objects that have table level faces that are concentric or that answer to the same idea (like ball brgs). When I add a brim to help with table adhesion it only shows up on the outer periphery of the part. I can understand looking at the layer in contact with the table as the outer faces in x y of the part. But there are "outer" faces on the enclosed geometry layer in contact with the bed too. Can we have brims look at all faces in contact with the bed and not just the faces at the x y extents? In the mentioned ball brg the brim shows up on the outer race but not the inner.
Re: Brim on inner race of bearing
There have been a handful of occasions when I wished this feature was available, and instead settled for a raft, or had to design an interior brim on the cad file prior to importing it into s3d. +1 from me.
