HI
I am trying to get the print to pause at a given layer for a filament change, so far I have tried {REPLACE "\n; layer 3" "\n;M600,\n;layer 3,"} placed into the post-processing section but it does not work, the print just carries on. What is the correct formula for this to work, please.
My printer is running a DuetWifi with the latest software installed, RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.02RC4(RTOS) ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2018-11-18b5
