Posts: 1
Joined: Wed Jul 10, 2019 12:26 pm

Re: Modifier Mesh

Wed Jul 10, 2019 12:29 pm

I just purchased S3d and wow I’m disappointed it doesn’t have this feature. I came from ideamaker and it has this feature.

Is this going to release soon??

Posts: 782
Joined: Wed Jun 20, 2018 12:45 pm

Re: Modifier Mesh

Fri Jul 12, 2019 12:03 pm


Thanks for your interest in this feature being added to the software. I've documented this feature previously. I will continue to monitor this thread for additional interest and input.
"A bird does not sing because it has an answer. It sings because it has a song."

Posts: 3
Joined: Mon Aug 28, 2017 4:04 am

Re: Modifier Mesh

Wed Sep 11, 2019 9:02 pm

I can assure you there is massive interest in this feature. Being able to change infill parameters for parts of a model saves a lot of time and material on huge models on a Creality S5. Why infill the whole model at the densest requirement when only a small part needs dense infil? And sadly this part can not be separated by layer height.

Posts: 11
Joined: Sat Feb 24, 2018 1:10 pm

Re: Modifier Mesh

Mon Sep 16, 2019 12:04 pm

i vote for this on too

Posts: 3
Joined: Mon Dec 24, 2018 11:10 am

Re: Modifier Mesh

Sun Sep 29, 2019 10:14 am

I'd like to vote for this as well. Slic3r isn't very good in other regards, so S3D is still my slicer of choice. I can't really do threaded inserts with S3D, as I need to change the number of perimeters for the entire part rather than just the places the inserts go.

Hopefully it'll make it into v5

Return to “Feature Requests”