Raft on only one part?

[alexzogh]

Hi,

I'm trying a multi-part print, but only want a raft on one of the parts. I set up two processes, one with a raft selected, and one part (staircase) with the raft and 3 other parts with the raft deselected. It seems no matter what I do, it prints a raft under all four parts. Is this a software bug?

Things I've tried:

changing the 'order' of the processes. increasing the distance between parts, sequential printing between the processes (2mm is the max I can do)

Factory file is too big to attach, but you can get it here:

https://drive.google.com/file/d/1I95bST ... sp=sharing

[S3D-Chris]

Try reducing the raft offset from part value and make sure your parts are spread out far enough on the bed to make sure they do not share additions.

[twofirstnames]

Thank you S3D Chris! I've been struggling with this for an hour.

Solution for all: "make sure your parts are spread out far enough on the bed to make sure they do not share additions"