Simplify3D is like a holy grail after struggling to properly calibrate the finer points of my Lulzbot Taz 4 with other slicers. I am busy running a 3d print business with several printers and the TAZ it has been sitting on the sidelines for months, just not able to deliver the results I was needing. Then yesterday I tried Simplify3D and everything changed.
Not only is the TAZ 4 now working, its producing better prints than the MakerBot and the Up plus 2. I am super impressed. Looking forward to running simplify 3D in place of makerware as well. Any recommendations on work-flow for using the software with multiple printers? Thanks to great software to whip this wild TAZ hardware into shape!!!
Noah
-
NoahHornberger
- Posts: 6
- Joined: Mon Nov 24, 2014 9:47 am
-
KeyboardWarrior
- Posts: 480
- Joined: Thu Jun 19, 2014 5:02 pm
Re: Super Impressed !! and a question
Lulzbot uses really good materials when building their printer I can see why you're getting great results!!!!!!!
-
palawanisland
- Posts: 22
- Joined: Tue Jul 29, 2014 3:56 pm
Re: Super Impressed !! and a question
you can save profiles for each machine / material per machine / etc..
Re: Super Impressed !! and a question
Noah,
Could you post your TAZ 4 settings/factory file? I am almost finished with my KITTAZ build and I am super pumped about getting it started in Simplify 3D. I think it coudl be a winning combination, TAZ+Simplify3D.
Thanks,
KosmoPi
Could you post your TAZ 4 settings/factory file? I am almost finished with my KITTAZ build and I am super pumped about getting it started in Simplify 3D. I think it coudl be a winning combination, TAZ+Simplify3D.
Thanks,
KosmoPi
