[FIXED] no profile is loaded if you open an STL on the desktop

[perry4916]

no profile is loaded if you open an STL on the desktop. (so it starts V5)

if you open V5 normally, then you will have a profile loaded.

[S3D-Jason]

Are you saying that there's no processes in the list on the left? Was there already processes in that list when you last shut down the software?

[perry4916]

correct.

When I start the program normally. there is a process on the left.


But when the program is closed and I double click on an STL so it will open the program , then there is no process, and i need to assign a new process again.

[S3D-Jason]

Thanks for reporting this. I will be sure to share it with the team.

Did you by chance use V4 on this same computer? Does it have the same behavior?

[S3D-Jason]

This was fixed in our latest Version 5.0.1 release. Please update to the latest version of the software and it should now behave better when launching the program using a STL file.

You can see all of the other changes here:
https://www.simplify3d.com/products/sim ... ase-notes/