M180 Malyan (3D FreeSculpt EX2)

[helmutdz]

I have a M180 Malyan (3D FreeSculpt EX2) clone and get him not to run with Simplify.
can any one help me with the settings.

[KeyboardWarrior]

I have a M180 Malyan (3D FreeSculpt EX2) clone and get him not to run with Simplify.
can any one help me with the settings.

I don't know if that's a very common printer. Have you tried contacting Simplify3D's support?

[helmutdz]

I don't know if that's a very common printer. Have you tried contacting Simplify3D's support?

I'm already in contact with the support.
The printer is distributed in Germany by the company Pearl.
Only the support rather bad at Pearl.
because it only sell and do not manufacture itself.

[acefx]

Same here , the malyan M180 seems to be a replicator x2 clone but without the usual "compatibily" of the clone.
the hardware seems to be ok but the software support is just shitty !
if anyone is interessted making a wiki with profile and tips and trick about this printer, we may combine our exeperience to do it !

[Alan]

What has been the problems found when using the M180 with Simplify3D ?

[helmutdz]

Same here , the malyan M180 seems to be a replicator x2 clone but without the usual "compatibily" of the clone.
the hardware seems to be ok but the software support is just shitty !
if anyone is interessted making a wiki with profile and tips and trick about this printer, we may combine our exeperience to do it !

I would be great if we could exchange experiences

[helmutdz]

What has been the problems found when using the M180 with Simplify3D ?

das größte problem ist die Z axis, die bewegung ist zu gering.
bei einen externen aufruf von GPX kann ich das ändern.