-
WonderNomad
- Posts: 3
- Joined: Wed Apr 16, 2025 5:33 am
Ender 3 with Simplify3D
Trying to dial in bridging on my Ender 3 with Simplify3D. Using PLA, 200°C, but bridges are sagging. Should I lower speed or increase cooling?
-
S3D-Taylor
- Posts: 102
- Joined: Tue Jun 20, 2023 10:55 am
-
brattney02
- Posts: 1
- Joined: Tue Apr 22, 2025 4:55 am
Re: Ender 3 with Simplify3D
I've had similar issues! Increasing the cooling usually makes a big difference for bridges. Maybe try lowering the temp a bit too if it's still sagging.WonderNomad wrote: ↑Wed Apr 16, 2025 11:16 pm Trying to dial in bridging on my Ender 3 with Simplify3D. Using PLA, 200°C, but bridges are sagging. Should I lower speed or increase cooling?
