v5.1.2 - does not list support for Bambu P1S?

[blobabee]

Hello,

I checked the supported printers list on the main Simplify3D page, and it says the Bambu P1S is supported, but it only lists the P1P, X1 and X1 Carbon and I have Simplify v5.1.2.

Can anyone help as to why it does not show the Bambu P1S or is it essentially the P1P? If it's essentially the P1P, then it should show the selection as 'Bambu P1P / P1S' for best representation.

Thanks much.

[S3D-Jason]

I would try contacting our team directly at the link below and they can point you to the correct profile.
https://www.simplify3d.com/contact-us/

[blobabee]

Thanks Jason. I took your advice and sent that to support. There are more differences between the two printers. Especially with the fans, so I'm looking forward to the reply