Elegoo Carbon

[LGGreen]

I have just started using an Elegoo Carbon for my 3D printing. I have the profile loaded into Simplify 3D. The print always prints a skirt even though skirt brim raft ooze shield are not selected. How can I stop the skirt being printed?

[S3D-Taylor]

Hi, could you attach the factory file here so we can take a look at it?

[LGGreen]

Oops. My fault.. I was repeating a badly sliced version of the gcode file that was on the printer rather than the later version that I had on the usb drive!