Speed after slicing not matching settings

[dunginhawk]

Good evening... So i just sliced at 40mm/s for everything... and 80% of that speed for first layer.
WHen i slice it and look at the color guide, its not even close...

Its showing first layer at like 5mm/s (which after a test print, seems about right)
It shows no more than 20-25mm/s for the rest of the layers. A tiny bit of green (showing around 40mm/s) on some outer layers.

All the settings are showing as I set them. My FF Creator pro has acceleration enabled (not that would matter in the slicer).

any thoughts?

thank you

[jimc]

Look in the cooling section. If the layer taks less than x seconds to complete then it will slow the layer down x%.

[dunginhawk]

Jim,, first off, thanks for responding.. Your parts you make are stunning... quite amazing.
I have checked that, and its unchecked... this is a large print, most layers take 15 minutes

its strange, when i ramp up the speed to 70mm / s it shows accurately.
its only at 20-40mm/s or so that the color seems to be wierd..
perhaps its just the color wheel is off?

[dunginhawk]

so strange. im printing a raft and im set first layer to 80% and the normal speed set in other is 65mm/s so 80% of that is in the 50s.. its only going about 10mm/s right now . something seriously wrong.
acceleration on my ff pro is enabled.

[jimc]

thanks! i am a little unfamiliar with the whole MB/sailfish thing and the quirks of how s3d works with it. did s3d used to work correctly and now this is a new issue that has popped up? if so i would got help/reset all settings then go back and load a default profile and change your settings from there. see what happens. i cant think of anything else other than the cooling overrides that would kick in and change the speeds. do it do this with just this model? have you tried others?

[dunginhawk]

ive only tried this model at this point.. good thought on switching..
so s3d is a fresh install with a brand new printer... so it should be pretty pristine.

[jimc]

i would assume you've taken notice where your outline and solid infill speeds are set right? they will decrease a % or the print speed.

[dunginhawk]

yep. for testing purposes i set them all to the same as the base printing speed.
thanks