Fast printing and PETG. Need help with zits/gaps

[StealthPrint]

Just changed over from Slic3r hoping S3D would allow me to clean up my prints as I print fast after I exhausted lin advance... I have no problems with PLA at these speeds, yes I am aware I can "turn it down" but that doesn't interest me.

Here is my latest benchy.





Settings.






Marlin config
2500 X Accel/ 30 X Jerk
1100 Y Accel/ 6 Y Jerk (had to turn this down from slic3r where i was at 10 jerk and 1350 accel, any higher I get layer shift with S3D)
8 Extruder Jerk

Printer Info;
Wanhao I3 Base
E3D V6 + Bowden Titan
217 Gram X carriage (Including bearings/blocks/fans/hotend/tensioner/all of it)
300x200 Print bed
Bracing
MKS Gen L
TMC2130 X/Y
A4988 E/Z



I appreciate any input, would love to hear from other people who also like to print fast.

[wirlybird]

Can't see any of your images. The first thing is that PETG simply doesn't like to be printed too fast. I generally never go over 40mm/s.

[airscapes]

+1 If you want PETG to be clean, slow down. Especially xy travel speed (speed tab of S3D)