HI
I need to change filament at a given layer.
I have tried putt the following in the post-processing segment.
{REPLACE "\n; layer 7," "\n;***PAUSE***\nM83\nG1 E-1.0 F6000\nG91\nG1 Z5.0\nG90\nG1 X10 Y10 F6000\nM84 E0\nM0\nM82\nG92 E0\n;layer 7,"}
which should stop it at layer 7 move head to the front side and wait till resume is given, however it stops at that layer but the heater then goes off and then there is no way to restart the print
I am using a Duet board which runs reprap
