Here is some photos of what it looks like.
Regards,
Alex
Print failing after raft is complete.
I have a Flashforge Guider 2S and I just bought Simplify3D I cannot get a single print to work with a raft as the printer seems to fail to adhere to the raft but worse extrusion also seems to stop altogether. This does not happen with Flashprint at all. So the printer works fine.
Here is some photos of what it looks like.
I also cannot seem to connect to my printer via Wifi. Is this possible? I like simplify3D but if it will not work properly with my printer i will refund.
Regards,
Alex
Here is some photos of what it looks like.
I also cannot seem to connect to my printer via Wifi. Is this possible? I like simplify3D but if it will not work properly with my printer i will refund.
Regards,
Alex
Re: Print failing after raft is complete.
Our software doesn't currently support Wifi connection with this printer. We have the Guider II in our office and would be more than happy to help you troubleshoot this extrusion issue once your part starts above the raft. Please contact our support team for more thorough investigation of the issue.
"A bird does not sing because it has an answer. It sings because it has a song."
