The only issue I now have is that there is a small void where the printer finishes a wall and then moves on to building the infill as can be shown here:
does anyone have any ideas on how to solve this?
also random layer start doesn't work:
Small voids on layer change / where walls meet infill
Hello all, being trying to perfect my 3d print quality for TPU for what seems an eternity.
The only issue I now have is that there is a small void where the printer finishes a wall and then moves on to building the infill as can be shown here:
does anyone have any ideas on how to solve this?
also random layer start doesn't work:
The only issue I now have is that there is a small void where the printer finishes a wall and then moves on to building the infill as can be shown here:
does anyone have any ideas on how to solve this?
also random layer start doesn't work:
Re: Small voids on layer change / where walls meet infill
I think it is sink (to use a molding term) where the plastic cools and pulls in. Try cooler, slower, or more fan.
Re: Small voids on layer change / where walls meet infill
Nevermind, I didn't zoom in enough.
Too much coast if it's at the end of the perimiter, not enough prime if at start).
Too much coast if it's at the end of the perimiter, not enough prime if at start).
