Printing problem, juice in pieces

[FOXYCTG21]

I am printing visors, and with the rapid movement of one leg to the other a trickle of thread comes out and then sticks to the print.
I also have problems with retractions, leaving a plastic flow in the impression, making visible the area where it retracts and also areas with seams.
Elsewhere there is excess material.

The printer I have calibrated the steps, and also the temperature of the plastic.

[S3D-Alex]

It sounds like you are dealing with stringing and maybe some blobs and zits. Have you had a chance to check out our Print Quality Guide? It has great advice for dealing with issues like these.

https://www.simplify3d.com/support/prin ... eshooting/