Top & Bottom Layers Over Lap Shells

[bray.christopher]

I would like it if the top layer over lapped or inter lapped with the shells.

If I am using low infill, sometimes the ends of the top layers don't land on anything. There is a similar feature for bridging that allows you to define how much of a landing the bridge has.

X = Shell
0 = Top or bottom layer
F = Infill

Current:

XXX00000000XXX
XXX00000000XXX
XXX00000000XXX
XXXF F F F FXXX
XXXF F F F FXXX
XXXF F F F FXXX
XXXF F F F FXXX
XXX00000000XXX
XXX00000000XXX
XXX00000000XXX

Proposed:

X000000000000X
X000000000000X
X000000000000X
XXXF F F F FXXX
XXXF F F F FXXX
XXXF F F F FXXX
XXXF F F F FXXX
X000000000000X
X000000000000X
X000000000000X

OR:

X000000000000X
XXX00000000XXX
X000000000000X
XXXF F F F FXXX
XXXF F F F FXXX
XXXF F F F FXXX
XXXF F F F FXXX
XXX00000000XXX
X000000000000X
XXX00000000XXX