Hello,
I just discovered the "Allow Single Extrusion Fill" option under Think Wall Behavior, which has reduced build time significantly on some large prints.
However, the quality of this kind of infill is such that it can look quite bad on top (external) layers. It would be very nice to be able to turn this on for all the internal layers, but revert to the standard rectilinear/raster pattern infill for any top surfaces.
*For anyone who hasn't tried this option, it's for cases where the walls are thin enough that the infill could be made with just a single extrusion along the wall's length instead of many minute raster movements, which can really kill the build time.
~Justine
