Differential layer high for quicker prints

[astrojose9]

Hello,

I don't know if this could be possible but I am thinking about a feature that could lead to lower printing time:

If one wants to print in 100μm layers but still have a somewhat acceptable printing time could it be possible to print two layers of the shell in 100μm and then one 200μm infill layer?

Thank you

Cheers
José

[rrdavis]

You can already do this. Just set the main layer height to 0.1mm, then go to the Infill tab and tell it to "combine infill every 2 layers". That will print a 0.2mm thick infill layer for every two 0.1mm outlines. That way you get high speed, but still good quality.

[astrojose9]

Oh okay thank you very much for you help and to help me expand my s3d knowledge